Available from JGS4x4 – Land Rover Defender Clutch Pedal Assist Kit – DA1266
For 5-10 mins of you time to fit for about 50% easier to push clutch.
Replace the old clutch pedal spring kit to assist the pressing of the clutch pedal on Defender models. This is a factory fit on later models but can be retro fitted to all 90/110 models. Consists of spring, spring retainer & spring bushes
Remove the original spring, not a hard job just use your favourite prying tool.
Once removed you can fit the pedal assist kit. Fit the bearing (No 3 in the picture) this hooks into the latch behind the pedal. A good bit of force may be required, so some WD40 or similar lubricant is a good idea.
Now you will need to fit the two bearings (No 4 in the picture) to each side of the pedal. Again you may need to use some force so a squirt of WD40 again.
Lastly fit the spring. Clip the centre of the spring into the bearing (No 3) behind the pedal. Pressing the clutch pedal down fit the sides of the spring into the two bearings (No 4)
Now enjoy your easier clutch pedal!
Hi there, how Much does the pedal assist kit cost please? Including postage to Cardiff.
Many thanks
Regards
Mark
Hi Mark, If you click on any of the above links in the article it will take you through to the item page where you can see more info, the price and buy it if you wish.